在线一本码道高清

Hyundai ix35 pull cylinder

2019-12-29 09:08:18

Hyundai ix35 will go to the repair shop to repair the cylinder:

1. The engine cylinder is called a cylinder because of grooves on the inner wall of the cylinder bore due to improper use or repair of the car. The degree of pulling the cylinder is different, and the deep line, area and length of the groove marks are also different;

2. The main reason for the cylinder is that the piston quality does not meet the standard, the expansion coefficient is too large or the size does not meet the technical requirements; the piston ring backlash or end gap is too small, and the gap between the piston and the cylinder wall is too small or dirty during assembly. ;

3. The engine is poorly lubricated, the lubricating oil quality does not meet the technical standards, the engine cooling system is short of water or the engine is running in an overheated state, and the engine slams the throttle for a long time just after the engine is started;

4. The engine does not implement the technical requirements of the run-in during the run-in period, and runs at high speed for a long time.

Through the above introduction by Xiaobian, I don't know if you have any idea about Hyundai ix35? I hope these introductions will be helpful to you.

related articles

Cause analysis of engine cylinder

Cause analysis of engine cylinder

Car maintenance knowledge 12-14


Pull cylinder refers to the severe surface damage caused by various reasons when the piston reciprocates in the cylinder. Most of the damage is caused by the local damage of the lubricant film of the moving parts, and the high temperature of the engine ...

Cancel reply to post your comment:

Hot recommendation